How to Pull Up Carpet and Lay Laminate Flooring – Carpet Cleaning Fort Dodge


The rough surface is fixed to the floor using nails or glue. It is necessary to wear safety glasses and gloves to protect your hands. With safer tools, they won’t damage your floors, your walls or glass doors. Most of the tools you require are in your toolbox. In the event that you’re not able to locate what you’re searching for, there’s always a local hardware shop. A good set of tools will simplify your work and take a short time.
You can begin pulling the Carpet From One Corner

Select one corner of the carpet. Pull it out from the corner. Take care not to touch the stripes of tack that run along the edges. They’re razor sharp and might prick you. If your carpet isn’t budging, no matter how much force you apply, get your utility knife, and cut a rectangular piece near the corner. From there, you can begin to rip carpet off the floor.

Make the Carpet in Strips

In the process of peeling the carpet, apply the utility knife to cut the carpet into sections. 2 feet is sufficient. Be sure to keep your line straight even though there is no need to take measurements. For straight lines one can use their eye. It is also a way to dispose of carpet. The issue isn’t that the lines don’t line up. It’s not your intention to reuse carpet. Apply tape to the edges of each strip to secure it. It is easy to carry them to your disposal place. An important step to remember when you’re getting familiar with how to tear up carpets and lay laminate flooring, is to know how to dispose of padding and carpet. Do you have any limitations within your region on how can be disposed of with this type of material? There is a need for a hauling firm if you are unable to put things into the trash container to be picked up by the regular garbage collection. The hauling service will pick up garbage and dispose of it safely. it.

Take off the Tack Strips

After that, you must remove the strips of tacks. The tack strips, which are tiny pieces of wood scattered with nails or tacks for carpet installation, are very small. Because they are rough and spikey, you should not attempt to pull them out using gloves. Flat head screwdriver

4jajt61p77.